Table des matières

Tutoriels MAX7219 avec matrice 8X8

Liens web tuto MAX7219

Programmes

Préparation Logiciels

Utiliser ou télécharger la dernière version de l'IDE Arduino

Le diagramme de synchronisation pour Max7219 et son format de données série sont joints ci-dessous avec ses caractéristiques électroniques.

Un programme de test sans librairie à inclure
exemple_code_MAX7219.ino
 unsigned char i;
 unsigned char j; 
/*Port Definitions*/
int Max7219_pinCLK = 10;
int Max7219_pinCS = 9;
int Max7219_pinDIN = 8;
 
unsigned char disp1[38][8]={
{0x3C,0x42,0x42,0x42,0x42,0x42,0x42,0x3C},//0
{0x10,0x18,0x14,0x10,0x10,0x10,0x10,0x10},//1
{0x7E,0x2,0x2,0x7E,0x40,0x40,0x40,0x7E},//2
{0x3E,0x2,0x2,0x3E,0x2,0x2,0x3E,0x0},//3
{0x8,0x18,0x28,0x48,0xFE,0x8,0x8,0x8},//4
{0x3C,0x20,0x20,0x3C,0x4,0x4,0x3C,0x0},//5
{0x3C,0x20,0x20,0x3C,0x24,0x24,0x3C,0x0},//6
{0x3E,0x22,0x4,0x8,0x8,0x8,0x8,0x8},//7
{0x0,0x3E,0x22,0x22,0x3E,0x22,0x22,0x3E},//8
{0x3E,0x22,0x22,0x3E,0x2,0x2,0x2,0x3E},//9
{0x8,0x14,0x22,0x3E,0x22,0x22,0x22,0x22},//A
{0x3C,0x22,0x22,0x3E,0x22,0x22,0x3C,0x0},//B
{0x3C,0x40,0x40,0x40,0x40,0x40,0x3C,0x0},//C
{0x7C,0x42,0x42,0x42,0x42,0x42,0x7C,0x0},//D
{0x7C,0x40,0x40,0x7C,0x40,0x40,0x40,0x7C},//E
{0x7C,0x40,0x40,0x7C,0x40,0x40,0x40,0x40},//F
{0x3C,0x40,0x40,0x40,0x40,0x44,0x44,0x3C},//G
{0x44,0x44,0x44,0x7C,0x44,0x44,0x44,0x44},//H
{0x7C,0x10,0x10,0x10,0x10,0x10,0x10,0x7C},//I
{0x3C,0x8,0x8,0x8,0x8,0x8,0x48,0x30},//J
{0x0,0x24,0x28,0x30,0x20,0x30,0x28,0x24},//K
{0x40,0x40,0x40,0x40,0x40,0x40,0x40,0x7C},//L
{0x81,0xC3,0xA5,0x99,0x81,0x81,0x81,0x81},//M
{0x0,0x42,0x62,0x52,0x4A,0x46,0x42,0x0},//N
{0x3C,0x42,0x42,0x42,0x42,0x42,0x42,0x3C},//O
{0x3C,0x22,0x22,0x22,0x3C,0x20,0x20,0x20},//P
{0x1C,0x22,0x22,0x22,0x22,0x26,0x22,0x1D},//Q
{0x3C,0x22,0x22,0x22,0x3C,0x24,0x22,0x21},//R
{0x0,0x1E,0x20,0x20,0x3E,0x2,0x2,0x3C},//S
{0x0,0x3E,0x8,0x8,0x8,0x8,0x8,0x8},//T
{0x42,0x42,0x42,0x42,0x42,0x42,0x22,0x1C},//U
{0x42,0x42,0x42,0x42,0x42,0x42,0x24,0x18},//V
{0x0,0x49,0x49,0x49,0x49,0x2A,0x1C,0x0},//W
{0x0,0x41,0x22,0x14,0x8,0x14,0x22,0x41},//X
{0x41,0x22,0x14,0x8,0x8,0x8,0x8,0x8},//Y
{0x0,0x7F,0x2,0x4,0x8,0x10,0x20,0x7F},//Z
};
 
 
 
void Write_Max7219_byte(unsigned char DATA) 
{   
            unsigned char i;
	    digitalWrite(Max7219_pinCS,LOW);		
	    for(i=8;i>=1;i--)
          {		  
             digitalWrite(Max7219_pinCLK,LOW);
             digitalWrite(Max7219_pinDIN,DATA&0x80);// Extracting a bit data
             DATA = DATA<<1;
             digitalWrite(Max7219_pinCLK,HIGH);
           }                                 
}
 
 
void Write_Max7219(unsigned char address,unsigned char dat)
{
        digitalWrite(Max7219_pinCS,LOW);
        Write_Max7219_byte(address);           //address,code of LED
        Write_Max7219_byte(dat);               //data,figure on LED 
        digitalWrite(Max7219_pinCS,HIGH);
}
 
void Init_MAX7219(void)
{
 Write_Max7219(0x09, 0x00);       //decoding :BCD
 Write_Max7219(0x0a, 0x03);       //brightness 
 Write_Max7219(0x0b, 0x07);       //scanlimit;8 LEDs
 Write_Max7219(0x0c, 0x01);       //power-down mode:0,normal mode:1
 Write_Max7219(0x0f, 0x00);       //test display:1;EOT,display:0
}
 
 
 
void setup()
{
 
  pinMode(Max7219_pinCLK,OUTPUT);
  pinMode(Max7219_pinCS,OUTPUT);
  pinMode(Max7219_pinDIN,OUTPUT);
  delay(50);
  Init_MAX7219();
}
 
 
void loop()
{ 
   for(j=0;j<38;j++)
  {
   for(i=1;i<9;i++)
    Write_Max7219(i,disp1[j][i-1]);
   delay(500);
  } 		
}
Programmes avec librairies à inclure
Librairies

Différentes librairies à tester

Une librairie pour les matrices en cascade ( à essayer …)

Une autre librairie mais pour le Raspberry ( A voir lors d'une autre soirée …)

Pour la création de codes pour matrices de LEDS

Envoyer par Fernand

8x8 Matrix Character Creator

Pour la création de caractères 8×8 sur la matrice de LEDs

Toujours envoyer par Fernand : un programme de test, ne pas oublier d'inclure les 2 librairies ci-dessous

Matrix 32x8 Max7219